Skip navigation

Log in to create and rate content, and to follow, bookmark, and share content with other members.

AnsweredAssumed Answered

Hello, I am new to SolidWorks and was wondering if someone could explain how I could design the following object:

Question asked by Mike Barsky on Aug 18, 2014
Latest reply on Aug 19, 2014 by Doyle Ramsey

Like • Show 0 Likes0
Comment • 2

No one else has this question

Outcomes

2 Replies

Chris Mackedanz Aug 18, 2014 12:00 PM
Mark Correct
Correct Answer
Two revolves, a cut extrude, and then some fillets.
Like • Show 1 Like1
Actions
Doyle Ramsey Aug 19, 2014 9:33 AM
Mark Correct
Correct Answer
just like Chris Mackedanz said two revolves (one for the donut & one for the boss), a cut extrude (to make the indents on the inside of the donut) and fillets to round off the boss and cuts.
took me less than ten minutes
Like • Show 1 Like1
Actions

Recommended Content