i need to create a crown gear, there isnt an option for that in the toolbox, any suggestion?
We have GearTrax. I don't see a place to make crown gears specifically but it can do bevel gears and you can set the pitch angle to 90 degrees. It kinda works. I've attached an example of one I just made. Do you need models for a lot of different sizes or just one or two? I could probably crank a couple out for you if you give me the specs.
Have you tried sites like GrabCAD?
Have you tried manufacturers websites
Have you tried modeling from scratch?
yes X 3,
nothing until now, i'm looking for a tool like GearTeq.
thanks! but i'm using ver 2013, so i will have to wait until sunday, and check it on University's copmputer.
do you have it on 2013 maybe?
thanks again, both of you!
Sorry I only have 2014, but here is a parasolid in case you want to look at it now.
can you give me the parameters which you used to create it? accept pich angle of 90?
You need GearTraxPRO-2014. The Spur/Helical tab is used. Select "Face" for the pinion Gear Type.
Retrieving data ...