paul braithwaite

SW AND EDGECAM

Discussion created by paul braithwaite on Mar 16, 2007
We are currently using SOLIDWORKS to design our components and EDGECAM to generate our tool paths. When we have the two programs open together the PC becomes very unresponsive and tends to run at a snails pace. We understand that EDGECAM will only support 2G of RAM and is not multi threaded so EDGECAM seems to be the problem. Has anyone else run into this problem and are there any ways round it because it is desirable to have the two packages open together. We have invested a lot of money and training in EDGECAM so it will not be a case of throwing EDGECAM in the trash.

Thanks

Outcomes