AnsweredAssumed Answered

Dimensions from Configuration properties from Design table?

Question asked by Campbell Dear on Aug 3, 2014

Hi guys, first post!

 

I'm having trouble driving a models dimensions through a design table. My workflow is to define configuration specific properties in the design table, then link the dimensions in the model to these properties. I don't want to drive the dimensions directly from the design table because I'll use a lot of the properties again elsewhere in the model.

 

What's happening is when I link a dim to a config property, the dim then stays locked to that one config property even when I switch to another config.

 

I've made sure there are no spaces in the config property names, and it doesn't seem to matter if I click "This configuration only" before linking the dimension to the config property. Not sure what I'm doing wrong? Probably something obvious! Apologies if this was answered elsewhere, I couldn't find anything.

 

Cheers,

Campbell

Attachments

Outcomes