I'm looking to set up a website where the consumer would be able to make changes to the model.
I'm not so interested in giving a creative input but more allowing them to make some simple changes in order to make the product functional eg: Shaft Diameter.
The objects would then be 3D printed.
I'm aware this is being done, with I think Openscad but I'm haven't found any good information on how to do so.
More recently amazon opened a 3D print store with some level of customization.
Ideally it would use SW models.
I'd be very gratefull if anyone has any information on how to do this?
Driveworks will do this.
All the best,
SolidWorks Simulation Training
Yess, just what I am after and it's included in SW.
Retrieving data ...