I am relatively new to solidworks but I need to model a part with relatively weird faces. I think the part is relatively easy to model, I just don't know how. I have attached three photos of the part. Any suggestions about how to approach this are much appreciated!!!!

Thank you!

Joseph Lee

Did you take a look at the part I attached? The way I made the angled plane is to first sketch a line on an existing plane or surface that is parallel to the new plane you want. So I sketched this on the bottom face:

Then I created a new plane using that line (coincident) and the Top Plane (30 deg angle).

You may need to fiddle around with both the angle of the original line and the angle of the plane to get it right where you want. Then once the angle is right you can make another plane with an offset if desired.