Are the options greyed out or missing?
Were different drawing templates used?
Check the Drafting Standard is the same for all drawings. Some standards don't allow leader-centred notes.
same template and standards Ansi for both documents
Have you submitted this to your VAR?
Run the SolidWorks Rx > Diagnostics tool to check for graphics driver compatibility.
Have you tried closing & re-opening SW, or rebooting the computer.
Can you simply copy the views into a new drawing?
I will give diagnostics a try (option shows up in other document though)
havent booted other than this morning startup
I was able to copy and past the annotation note into the new drawing and the options are now available.