6 Replies Latest reply on Jul 12, 2014 10:07 PM by Dave Krum

    fillets are reversed when saving part as .dxf file (change from internal radius to external)

    Dave Krum

      Good morning All,

      I've been having this issue since I started using SW but have been manually fixing it thru Autocad.  I'm tired of doing this if there is a setting that can easily be changed that I'm not aware of.  When I save a part file with internal radiused copes (ratholes for clearing welds) to a dxf file, almost always my internal radiused copes are reversed to an external radius on the dxf file from what is shown on the part.  I've attached my .sldprt file.  Can somebody confirm that what I'm seeing is what you see?  I've attached two snips, one showing what I should have on the .dxf file and the other what I'm actually getting.  Thanks.