I am modifing a 90 degree elbow by trimming about 1.5 inches on the end. Is there a way to show, in phantom, the removed part of the elbow?
Regards, David Tg
You may create a rectangle showing the removed area made with phantom lines.
You can make a configuration of the elbow before the remove, and a configuration after the remove. Then put the part in an assembly with two configurations, one with and one without the removed parts. Then if you put the assembly in a drawing you can use alternate position view to show the removed part in phantom.
You could also just draw 3 lines and then change them to phantom with the line format tool bar.
Retrieving data ...