Hi I'm looking for a simple one touch macro to do the following:
1. change "units" in "document properties" to fractions
2. set denomenator to 16
3. select round to nearest fraction.
Try the attached macro out. I created it in SW2012 by just opening a blank drawing and then hit record macro, do everyhting you asked then stop macro and save. If this doesn't work try the same in whatever version you are using and it should work. I tested it and it works (see pics below). All you have to do is save it somewhere and assign it to a button and your good to go. If you need help with that let me know and I will walk you through it.
Here is one macro to do it for batch of drawings: https://forum.solidworks.com/message/310960#310960
Thanks you were right, I didnt realize that the record macro button was that easy to use!
Appreciate the Help!
Retrieving data ...