"Source surface not define" Any body can help me ?

Discussion created by Designer Designer on Mar 2, 2007
Latest reply on May 3, 2007 by Vince Adams

Like • Show 0 Likes0
Comment • 3

Dear cosmos users.....

I have an assembly with pin connector. I want to run the study, but got an error message. ( see image below .... !!!! )
Any advice, please .... ?

Thank`s
-DD

Outcomes

3 Replies

Peter Gillespie Apr 25, 2007 8:06 PM
You probably already figured it out, but something in your model changed after you created that pin connection probably. "Update all components" sometimes will help, or delete & re-pinning can work.

But in your example, it's looking for the pin connector that was the 3rd created. I don't know exactly how that "ID 3" plays; it doesn't seem to be the 3rd pin connector, I think it is simply the 3rd connector or 3rd load/restraint created.
Like • Show 0 Likes0
Actions
- 1-6IQYAK @ Peter Gillespie on Apr 30, 2007 6:13 AM
  u didnt define connectors contact surface properly.
  you should define cylindrical contact surface each part
  Like • Show 0 Likes0
  Actions
  - Vince Adams @ 1-6IQYAK on May 3, 2007 9:01 PM
    If you changed any geometry near a previously created load, restraint, or connector, the ID of the entities used in the definition may have changed. Check your L/R or connector definitions.
    Like • Show 0 Likes0
    Actions

"Source surface not define" Any body can help me ?

Outcomes

Related Content

Recommended Content