AnsweredAssumed Answered

engraving process replication

Question asked by Jared Andrews on Jun 26, 2014
Latest reply on Jun 26, 2014 by Jamil Snead

I have a .dxf file that i am currently using in an engraving software to engrave an image on a part.

 

we are using the equivalent of a ball end mill .047 in. diameter and would like to make the image smaller but the lines may start running together.

 

I would like to put the .dxf in SW and replicate the .047 in. ball endmill at different depths of cut and different overall image sizes. the letters in the .dxf are made of lines and curves (i.e. no thickness)

 

any suggestions on the best way to do this?

Outcomes