AnsweredAssumed Answered

Can't mirror a helical sweep

Question asked by Kris Rowlands on Jun 25, 2014
Latest reply on Jun 26, 2014 by Kris Rowlands

I'm modeling a "U" spring and created the helical sweep of the coils offset from the right plane.

 

When I try to mirror that sweep around the right plane, it creates the mirror, but it does not appear in the part.

 

I only have one configuration in this part and see no reason why a helical sweep shouldn't mirror.......any advice you can give is greatly appreciated. I've attached the model.

 

Thanks in advance!

Attachments

Outcomes