AnsweredAssumed Answered

Would Love a Report for "Hole Alignment"

Question asked by Steve Martens on Jun 18, 2014
Latest reply on Jun 23, 2014 by Jody Stiles

I know it's too early for suggesting ideas for the next version, however I wanted to throw this out there for fun and knowledge.


The Hole Alignment tool is simple and gives good feedback, I have an assembly created from faro arm scanned parts that has hundreds of holes over 35 feet of plates, using the Hole Alignment tool to see how well they would fit if we just produced them right from the scanned files.


All that is under control, gonna be fine.  But what would be great is if I could print out a Report of how well the holes aligned, from the Hole Alignment tool.  Don't ask why, just because.