AnsweredAssumed Answered

How to create a 'V' shaped number cutout?

Question asked by Tdsi Tdsi on Jun 18, 2014
Latest reply on Jun 23, 2014 by Deepak Gupta



I am trying to create a number cutout for which the section profile of the number follows a 'V' shape. I can create the flat bottomed number cutout with no problem but I am unsure of how to go about creating the internal 'V' shaped profile of the number that I need. I have attached a screenshot of the current cutout that I have the bottom face that I have selected is where i would like the bottom of the 'V' profile to to be with each face of the 'V' leading up to the upper edges.


Any ideas on whether this is possible if so how to do it?


p.s I will also need to carry out this feature for all the numbers on a keypad (0-9 and the letter C) not just this number shown in the picture.