It is possible to show the unit deformation ( I'm sorry, I don't know the exactly word in english) directly in microstrain?
I'm asking about ESTRN.
For me it's more intuitive to see 100 ue than 0,0001 mm
You're ESTRN values are in mm? What version of SW are you using? SW14 shows up unitless.
Relly shows in mm/mm without units, but I would prefer see 100 instead of 0,0001, what I really see.
Instead of 679, I see 6.79e-004
I don't like, it is less intuitive
Change chart options to general
I had already tested, but the problem was the number of digits ( under general).
The problem is that in the spanish versión there is a bad translation that made me wrong.
Retrieving data ...