I have been attempting to make a simple route from one cable connector to another. I started by making the manufacturers part, then creating the line diagram symbol and wire diagram symbol. I also associated the 3d CAD drawing with the manufacturers part along with the symbols. I then created both the line diagram and schematics between these two parts. I created the wires, have everything referenced (that I know of) and create the Solidworks Cabinet Layout. I then open that up, input the 3d parts (which have the proper connection points and references located on them) and after I figure to be ready to route. After that no matter what I have tried I cannot get a 3d representation of the wires. I have watched tutorial afte tutorial and the only thing I can think of is that I have a setting off. Can anyone help?