6 Replies Latest reply on Jun 20, 2014 3:48 PM by Andrew Brown

    Is there a way to keep the rollback bar from automatically moving on rebuild?

    Sam Wells

      I recently made the switch to Solidworks 2014 and became aware that the rollback bar moves up to a broken feature automatically on rebuild. That part is fine, but I have also had it jump to that previous spot after fixing that broken feature and a few below it. I'm sure i could use the new freeze bar to help with my issue, but I would rather just disable the rollback bar's ability to move itself and control it myself.

       

      Any help is appreciated.

       

      Thank you!