5 Replies Latest reply on Jun 11, 2014 2:33 PM by Carlos Alfaro

    Can not Mate two flexible sub-assemblies in a ssembly

    Carlos Alfaro

      Hello everyone,

       

      I am currently in the middle of working the assembly shown below, as you can see I have two flexible assemblies that I am trying to mate to one another. The models shown are a slide rail (flexible assembly) and a cable guide (flexible assembly). The end goal is to have the cable guide travel along with the the rail but being that the assembliy becomes "fully defined" once the front end is mated this will not allow me to mate the rear part of the cable guide. The strange part is that both assemblies are still flexible but no longer can be mated to one another, any suggestions on how to mate these two flexible sub-assemblies so that I can reach my end goal?

       

       

       

       

      Mating Issues.JPG