AnsweredAssumed Answered

Multiple Lofted Sections in Sheetmetal

Question asked by Luke Seed on May 31, 2014
Latest reply on Jun 4, 2014 by Mark McMullen

Hi,

 

I'm desperately trying to figure out how to convert this part into a sheetmetal part.  It should be very easy but is maddenly difficult to figure out in solidworks.

 

The basic concept would be a rolled sheetmetal tube with a taper at the end.  To repeat that another way it would be a circular sheetmetal part with a lofted end.

 

0060014-01-Sheetmetal Shroud V2.JPG

 

Any suggestions?

 

Thanks,

Luke

Outcomes