0 Replies Latest reply on May 29, 2014 11:54 AM by Chris Scougall

    InspectionXpert

    Chris Scougall

      Does anyone know anything about InspectionXpert? I apologize if this isn't the right forum for this. I am running SW 2013 with InspectionXpeert as an add-in. I am trying to find a way to change the shape of some, but not all of the inspection balloons. (for critical diomensions). I can change the shape for all balloons, but can't seem to figure out how to have 2 different balloon shapes on the same drawing.

       

      Anyone have any thoughts?