3 Replies Latest reply on Jun 13, 2014 6:45 AM by J. Mather

Mates

Jon Ford May 28, 2014 11:51 AM

Hi Guys,

Managed to locate and download the attached cabinet hinge assembly, but unfortunately it hasnt been mated...

What I would like to have is it fully mated correctly so that the hinge will work correctly when I mate it to a cupboard door...

Any help very much appreciated as struggling!

Re: Mates

Mark Flederus Jun 6, 2014 8:04 AM (in response to Jon Ford)
Hi Jon,

I've opened the assembly and it looks to me that it is a imported file, likely STEP or IGES.

I've done some mate's and the hinge is working now as an hinge should work.

I am on a SW 2013 student version, I hope you can go further with your design.

hinge.rar.zip 4.1 MB
Like Show 0 Likes(0)

Actions
- Re: Mates
  
  Mark Flederus Jun 13, 2014 5:53 AM (in response to Mark Flederus)
  
  I hope this is what ment with your question.
  
  If it's not I would like to help further with it.
  
  If anyone else has this sort of problem, you are welcome and I would like to help you.
  
  Anyway ,good luck with your project.
  
  Like Show 0 Likes(0)
  
  Actions
Re: Mates

J. Mather Jun 13, 2014 6:45 AM (in response to Jon Ford)

If you use it as a sub-assembly be sure to set it's properties to Flexible in the main assembly.
Like Show 0 Likes(0)

Actions