AnsweredAssumed Answered

Trouble converting a swept feature to Sheet Metal

Question asked by Steven Carreno on May 21, 2014

Hello,

 

I recently created this part that will only need to curve in the z-x plane, but also needs to have a slope in the z-y plane.

Corresponding profiles are shown below.

 

Bottom Packing Table Outer Wall Right.JPG

I am having trouble converting this part to a flat pattern so it maintains the profile on the right.

I am  hoping to cut out the profile on the right and then bend it to match the curve on the left.

Any advice?

Thank you.

 

Best,

 

Steven

Attachments

Outcomes