1 Reply Latest reply on May 19, 2014 10:12 PM by Kelvin Lamport

    make pierce command missing

    Gary Milton
    Gary Milton May 19, 2014 7:52 PM

      hello all

      I cannot find the "make pierce command"

      when i do a search it comes back

      make pierce command not found in any menues or command ect ect

      sw2014

      i have also looked through all menues and tool bar customization .

      please help i am new to this .

      thanks gary

      • 1028 Views
      • Categories: SolidWorks
      • Tags:
        • Re: make pierce command missing
          Kelvin Lamport
          Kelvin Lamport May 19, 2014 10:12 PM (in response to Gary Milton)

          There is no actual "make pierce command".

          "Pierce" is a constraint between two sketch elements.

           

          PierceA sketch point and an axis, edge, line, or spline.The sketch point is coincident to where the axis, edge, or curve pierces the sketch plane. The pierce relation is used in sweeps with guide curves.