0 Replies Latest reply on May 16, 2014 7:44 PM by Mirko Tappero

    Solidworks and network performance

    Mirko Tappero

      Hi,

       

      As I travel a lot for work and as a result, I run my work off a Dropbox folder that I can access anywhere in the world. At my home office, I've had an issue for a while now where Solidworks would slow down (stall) whilst rebuilding after every five or so clicks / commands. After much investigation, I have boiled the problem down to my Netgear modem adaptor. Not that the adaptor itself is necassarily the problem, but when I unplug the adaptor (disconnect from the network) SW runs fine. Plug it in and the same stall issue. I've switched my anti virus off to no avail as well as my anti malware program. Any ideas??

       

      Regards,

       

      Mirko