Joel Schmidt

crashes after printing

Discussion created by Joel Schmidt on Feb 19, 2007
Latest reply on Feb 21, 2007 by Gerald Davis
I just updated to 2007 sp2.2 (from sp2.1) and now Solidworks stallsout all the time.  After printing any drawing (part, assembly,etc.), the following assembly drawing I open fails to opencompletely.  SW stalls, does not take any further commands,and must be terminated via Windows task manager.  Partdrawings open just fine.  It does not matter whether or notthe assembly itself is opened first (lightweight or resolved), thedrawing file still stalls out.  This did not happen with sp2.1.

Any suggestions?

Outcomes