AnsweredAssumed Answered

Problem with extrude cut

Question asked by Bevin Pettitt on May 15, 2014
Latest reply on May 15, 2014 by Bevin Pettitt

In the attached part (in SW 2013) when I try to Extrude Cut the "runner groove", I only have a "Through all" choice and no "Blind".  Why is this the case?

I drew the part originally as the LH side of a drawer with no problem.  But when I deleted the original runner groove sketch and re-drew it on the other side to produce the RH drawer side, the' problem occurs..

 

I suspect that the problem is modifying the original part.  I recognise I could simply draw the new part from scratch but I want to know why there is a problem now.

Thanks.

Bevin

Outcomes