Hi everyone, here is a question from a SW newbie. I try to convert this part to sheetmetal and add bend alone the dish line, so I can fold those open tab into a curved surface. However, I dont know how to add the bend.
Im waiting online.
Although there are no bends in you model you should be able to convert your solid to a Sheetmetal part using the "solid to sheet metal command" and it will be converted it to a SM part. You can then add the bend using the "sketch bend" command.
Hey Mark, Thank you a lot. Your advice is perfect worked on my case. I should use the forum more now.
Retrieving data ...