Any one here had the components of an assy appear above the ref planes, origin, etc?
SW wouldn't allow me to drag the parts below the origin, but it did allow me to add a new component which was placed correctly below the origin, and then I could drag the other parts below that new one. Deleted the new part and all is well again.
Not here. Everything just like always. Is it just one assembly?
Only one I've discovered so far anyway. It is a sub-assy but doesn't appear to have any ill effects on the upper level assys.
... and before anyone jumps in ... Yes I have run the SW Rx diagnostics.
It doesn't look like anyone else has chimed in. I know you've been doing this longer than I have, but was this sub-assembly created with a different template than your usual? I know it still shouldn't matter, but I can't think of anything else.
Same template used for all others. I've fired this of to my VAR so hopefully they will be able to shed some light on what happened.
It's not a big deal as it doesn't appear to cause problems, and can easily be rebuilt. Just curious as to what caused this to happen.
I'm about half convinced that my computer sometimes plays tricks on me for it's own amusement. Maybe yours does too?
Ctrl+Q? (I'm guessing you already did)
Nope, never seen that before!
Awesome! This solve lots of problem to me!
I have the same issue with some models, and if I try to add a new configuration it is corrupted.
Did you create the config before or after applying the fix I described?
Good! it works!
Thank you guys
Retrieving data ...