2 Replies Latest reply on May 9, 2014 1:28 PM by Dan Hofstetter

possible to apply inlet mass flow and surface source to same surface?

Dan Hofstetter May 8, 2014 2:35 PM

Hi,

Is there any way to apply an inlet mass flow (ammonia) to the same surface as a heat surface source (BTU/hr)? I have a project with a poultry barn, and we want to model ammonia emissions from the floor along with heat from the birds as well as barn ventilation.

Thanks,

Dan

Re: possible to apply inlet mass flow and surface source to same surface?

Jared Conway May 9, 2014 1:11 AM (in response to Dan Hofstetter)

assuming you already tried and it complained?

what about the flow rate in at a certain temperature instead?

or a heating element above the flow?
Like Show 0 Likes(0)

Actions
- Re: possible to apply inlet mass flow and surface source to same surface?
  
  Dan Hofstetter May 9, 2014 1:28 PM (in response to Jared Conway)
  
  Yeah, I tried and it complained. I even tried a disabled body above the floor but it complained about that, too. I can use the flow rate in at a certain temperature - I just have to convert the BTU/hr from the chickens to a temperature and average it with the floor temp to make it right - it should give the same results. Thanks!
  
  Like Show 1 Likes(1)
  
  Actions

Go to original post