Hello, i have a part with an inlet and outlet, short after the inlet the stream devides through 14 little tubes.
I want to see how much flow goes through each tube.
I tried to make a lid on each tube with the same pressure on both sides and made surface goals on them, but now the outlet volumeflow is higher than the inlet volumeflow.
Is there a possibility to get this right?
Please post a picture that shows what it looks like and where the boundary conditions are.
My suggestion would be to start simpler like 1 into 2 and then 1 into 3 to make sure your method is good before you go too far. It should work. My guess is a setup issue or convergence setup issue.
Retrieving data ...