Is it possible to dimension the slot with radial extension lines like it is shown in red in the picture below in SW? I am also only using SW12.
I believe if you set the view to see the construction circle you can use dimension to do this. Or you can create the construction line in the drawing and dimension it there as well.
I kinda figured it would have to be done line this and it has been how I was doing it all along. I was just hoping there was a to drag it and keep it radial at the same time that I didn't know about.
Yes you can, but you cant move the dimension out of slot. select on both the arc to create the dimension, if the dimension is not as shown in the image RMB select align to edge option and select the slot edge.
Retrieving data ...