AnsweredAssumed Answered

Qty of holes in hole callout doesn't match qty of holes created in part by HW

Question asked by Jacob Huckins on May 2, 2014
Latest reply on May 2, 2014 by Jacob Huckins

I am a new user to SolidWorks so this could be an obvious mistake that I am overlooking.  I created 5 holes in a part using the HW.  In the drawing I using the hole callout feature, but the quantity shown in the note is 6x. Looking at my part model, I broke the coincidence constraints on each point to move the hole and see if another was stacked on top of itself but only saw 5.  Any ideas on what would cause something like this to happen?

Outcomes