My company is transitioning from Inventor to SWX. I had the only license for eDrawing Publisher in Inventor. It worked fine until yesterday when I installed SWX Premium 2014 SP3.
Does anyone have any ideas how I might easily repair the 2013 publisher? Might it be as simple as redefining a pointer to an EXE?
Thanks!
Did you try re-installing or a repair install of eDrawings Publisher yet?
Cheers,
Anna
Although I am working this issue through my vendor, I believe my initial install was via download, so: No, I haven't tried to re-install. Thanks Anna!
Turns out all I needed to do was re-install as Anna suggested. I dug through the email trail, located the download server, tried to re-install, had to first un-install, then did the re-install. It picked up my original license, so all is good.
FWIW - conversion from Inventor to SWX seems MUCH faster from within INV using the Publisher than opening the assembly in SWX and saving as EASM.
Did you try re-installing or a repair install of eDrawings Publisher yet?
Cheers,
Anna