8 Replies Latest reply on Apr 29, 2014 6:18 PM by Aaron Campbell

    Trying to add a "through hole" on an almost finished part.

    Aaron Campbell

      Hello,

       

           I am trying to add a through hole to an almost finished part. I just can seem to get the two different angles right, and then I'm not sure how to create the hole. I've got the first angle right, this being the CL of the intended through hole, but then I need to revolve it 135deg and cut/extrude?

       

      .

      SWHELP.pngSWHELP1.png