Hi I tried to simulate my landing gear, but it constantly says i got problem with interferences..
I seriously have no idea what is happeneing..
Please have a look, seem I got problem with mating as i'm new in solidworks:((
Can you check your attachment - does not appear to be a SolidWorks file type?
its abstracted as there are a number of files, if you'd like to I can send you throught the email
when you do an interference detection in solidworks are there interferences?
Interferences in your assembly are supported for very few cases. One step in your addy prep should be to remove them.
This article is for flow, but the same applies to simulation.
i'd be happier if you could give me more practical help..
what do you mean by practical? the links i sent explain some pretty practical lessons about applying model simplifications to a model prior to running the analysis. where are you stuck?
I checked your assembly Danny, and I noticed you have alot of "Under Defined" sketches and that could be a problem, because when I ran a Interference Detection, I found around interferences, some on the Cylinder and some on the Spring,
my advice, is to re-check all your features and sketches, apply the missing dimenions and then re-mate your assembly without using the fixed mates -that you have alot in your assembly- and then run the "Interference Detection" feature under the tools menu, and make sure you don't have any errors or interference.
thank you for checking my parts really
what you are suggesting is basically deleted all the sketches that are not necessary.
am i right?
no need to delete the sketches, but just fix them, for example: in the sketch below, there is no Circle diameter, neither a dimension from edge to center or whatever dimension side you want,
that's what I've meant, and I would delete all the mate and remate them again,
looks like you import this model from another Software and just recognize the features, right?
oh yeah, well now there is no error in dimensions but it consistently says i got still interferences..
i did mate well tho eww..
First Fully constrain your Sketch in the Part Model.
Secondly Assembly in the proper way all your models,
Next Check now your Getting Interference or not.
If your getting Interference. Then Kidly look at your Intereference Parts.
Where your getting intereference. Then Check your Mating and Check your Model Dimensions.
Some time People May not Properly Mate some time Peope May Forgot to give orginal Dimensions,
For an example: In the Nut and Bolt If i give Bolt Shank Diameter (Outer Dia) 20 mm and nut diameter (Internal Dia) 18 mm. Then you will be Getting Intereference. To remove intereference you suppose to check the Model Dimensions. By changing the Nut Dia meter to 20 we are not getting Intereference or Changing the Shank Dia 18 mm.
Best of luck..
Retrieving data ...