I have a sheet metal plate that is twisted, one end large one end small, need help to create a blank for plasma cut.
This is not a parabolic skin as I depicted on my part.
I believe this is just a plate twisted top to bottom.
Can you show the parabolic curve from top to bottom with the twist?
hei'ya Viva, welcome to the forum,
need a bit more information to help you,
may be the file you have so far,
a screenshot and/or the dimmensions,
the specs or drawings/sketch
it will let more people see what your problem is
hei'ya Viva, I cann't see your post of a "parabolic skin" depiction,
can you attach an image/scrnsht, and/or upload the file,
use advanced editor- top right of the reply pane,
and insert image/attach file, to see what your model should be like-
you can inspect the part by expanding the display pane,
expand the features and hide/show each element - kelef
The part assy with the side skin was attached to my original note.
hei'ya Viva, I think you just need to produce your parabolic guides,
and then use loften bends from the sheetmetal features,
if I get a minute I'll see if I can emulate your pxr- kelef
hei'ya Viva, maybe the att.prt file will be of help,
examine the feature tree with the roll-back bar,
and post if you have any questions or problems
hope this helps- have a good'n kelef
Retrieving data ...