AnsweredAssumed Answered

Showing center mark outside of detail view

Question asked by Magnus Von Magnusson on Apr 24, 2014
Latest reply on Apr 24, 2014 by Glenn Schroeder

Salutations and thanks in advance fellow Solidworkers. Hopefully a simple question here, but a search including these forums and the googles yielded fruitless results.

 

I would like to show a center mark for an arc that is dimensioned in a detail view. However, the radius is large enough such that its center falls outside of the circular sketch that defines the detail view. Can I make this center mark appear in the detail view without it residing inside the detail's sketch boundary?

 

Much appreciated

Outcomes