Not sure what caused the error and im not sure how to fix it
I was able to create the wrap if the end lengths were reduced so that it does not go pass the end faces.
BUT now the wrap component and the created object is the same body and i am not able to separate them - Is there a function to create 2 BODIES and / or remove the base face. I am trying to avoid having to create another sketch to act as a mill and remove the base curve (if i created it using thin extrude)
Any suggestions greatly appreciated
hei'ya Xam, try the att.prt
hope this is helpful
have a good'n- kelef
Retrieving data ...