Hi Everyone,
As the title says, my table keeps outputting total lengths of the groups rather than each independant piece. I have no idea why its doing this. I've made many tables before, all without error, but today I get this. Could someone shed some light on the situation for me please and perhaps offer a solution.
Remo,
I would think one likely reason is if some of the bodies were inadvertently merged, but it's difficult to say without having the model. Can you post it? (Click on "Use advanced editor" at top right to post files.)
That was exactly it, "merge mitre trimmed bodies" was selected. No idea why it was on, but I've deselected it and it's given me the right lengths! thanks Glenn Schroeder!
Glad I could help.
Hello,
I have tried the,
deselected "merge mitter trimmed bodies" option too, But in drawings Length is not updating..
2 Question, Extrude (plate) Qty also not Updating (item :- 16) Showing 6 instead of 8 no.
kindly answer.
Thanks and Regards
Chetan kadamba..
deselected "merge miter trimmed bodies" option too, But in drawings Length is not updating..
Which body length you mean is not updating?
Question, Extrude (plate) Qty also not Updating (item :- 16) Showing 6 instead of 8 no.
In mirror 1 you've mirrored features instead of the bodies and that is why your total count is not correct. So delete that mirror feature and mirror again making sure you select the bodies.
Thanks for your reply...,
In the Cutlist....
Top frames. Lenght 1600, 1100 mm, these qty are not counting Properly
Thanks & Regards
Chetan
Because that is a general table with values manually typed in. It is not linked to the part model/cut list.
Dear Sir..,
I think both Tables are there.
manually typed for initial discussion. later i have extracted Weldment Cut list Tables,
In that 1100 mm weldment profile showing only one qty. But actually it is Two.
pls clarify..,
Chetan
I only see one table in the drawing which is a general table. Can you upload updated files with correct table and model.
Pls find the attachments
Issue for 15 and 17 are because of M20 Tapped Hole1 in which you've included one of the member.
Thank You ....,
I got the Solution...
Happy Ganesha Chathurthi..
Good Day,
Chetan
Remo,
I would think one likely reason is if some of the bodies were inadvertently merged, but it's difficult to say without having the model. Can you post it? (Click on "Use advanced editor" at top right to post files.)