5 Replies Latest reply on Apr 14, 2014 4:28 AM by Mark Wylie

    Mesh issues with parts in contact when changed from draft to high

    Mark Wylie

      Hi,

       

      I am running some non-linear static models in combined XYZ directions. The model solves with draft mesh but when I change to high quality I get an artefact of high stress where two bolted plates exist.

      Any ideas how to remove this? I have changed the non-penetration contact on the plate locations from node to surface and surface to surface with no sucess in removing this?

       

      Thanks,

       

      Mark