5 Replies Latest reply on May 4, 2014 9:45 PM by Steven Conrad

    Help with self-intersection in geometry following import

    Steven Conrad

      I received a SW model with an imported surface model that has two of the faces containing self-intersecting geometries showing up on Import Diagnostics. Attempts to heal these have failed. I have little surface modeling experience with advanced techniques, and unable to attempt to repair these manually. If someone would be willing to take a look at the model, I would appreciate it. The model may be proprietary, so I would rather send privately rather than publicly, if that is permitted in this forum.

       

      If this would be better posted in a different category, please advise.

       

      Steven Conrad, MD PhD

      LSU Health Sciences Center