So, I have this part with a fairly complicated countersink hole pattern, and they were put in using extrude cut and chamfer (someone else did this). Now I need to convert them into Hole Wizard holes, is there an easy way to do this?
You can export the model to a parasolids file, re-import it and go-through featureworks' recognition and see if it can pick up the faces and locations as a countersunk holewizard pattern, but I can't imagine that taking less time than recreating a hole pattern.
If you have 2014, you can delete the extrude cuts and chamfers without erasing the dependent features.
You'll probably have some clean-up work to do, but without seeing your part, that's the tack I would take.
Retrieving data ...