Do you guys have any idea about how to complete this part?
I really appreciate any help you can provide
PD: please check the attachment
Your image/part/?? didn't show up. There is a blank icon showing where something should be. Respond and click "use advanced editor" in the upper right to attach a jpeg/etc.
I can't open your file (I am on 2012), but from the image, it looks like you will have to do that in three sections; a sweep for the lip, an extrude for the flat section, and a loft or boundary for the transition. also, make use of symmetry, and only model a quarter and then mirror twice.
Thank you guys, i'll try and post my results
As far I can go just using sweep:
I'm trying the sweep/extrude/loft solution
any other ideas?
I created this by using a sweep and then used surfacing to fill in the inner portion. Tom
wow! that was fast! thank you so much Tom!
So may I presume that it is impossible to do this without surfacing?
No, if the center section is flat, you can probably do a simple extrude to fill it in.
Thanks for your reply Jerry but is not flat at all
Retrieving data ...