So I open a drawing to rev it up and most of my sheets have missing models, the current rev 6 so it's been working fine until now any ides. See pic
Welcome to SolidWorks forums Lupe.
Please try doing a force rebuild (ctrl+q) and check.
You might also find this post helpful for your future reference.
I have tried Ctrl-q, and no luck. However, I know what's causing it now, i need these drawings in high quality, so when i change it to high quality from draft quality, they vanish... Very frustrating!
Make sure that you drawing and models are opened up in resolved mode and not in lightweight mode. That might help.
Yup, I've tryed that too.
Please check the solutions mentioned in the SW KB.
Solution Id: S-062498 (related to using freeze feature) OR Solution Id: S-033309 (related to SpeedPak configuration)
Someone hasn't moved the the model to a different location on a disk drive, network drive? just a thought Tom
Although I use an older version of Solidworks, I have had the same problem.
Try going to the design tree and select the drawing view. Right click and select "hide". Then right click again and select "show".
Retrieving data ...