That's the error message. What am I doing wrong? When I assign connection points, I give it ciruit type and location.
Nelson Ouzts
CV Technology
SolidWorks Electrical 2D/3D 2014
That's the error message. What am I doing wrong? When I assign connection points, I give it ciruit type and location.
Nelson Ouzts
CV Technology
SolidWorks Electrical 2D/3D 2014
Nelson, This question seems to be a bit out of context. Can you show a picture of where you are assigning the connection points?
https://www.dropbox.com/s/v1v5ahgbii2tp7q/Screenshot%202014-03-12%2008.21.55.png
Please look at the bottle on the left hand side of the screen shot. I think the answer, however, is :
Do you maybe have the symbol type defined as “Schematic” instead of “Line Diagram”?
I'm going to look into it, when I have the time this morning.
Thanks
https://www.dropbox.com/s/v1v5ahgbii2tp7q/Screenshot%202014-03-12%2008.21.55.png
Please look at the bottle on the left hand side of the screen shot. I think the answer, however, is :
Do you maybe have the symbol type defined as “Schematic” instead of “Line Diagram”?
I'm going to look into it, when I have the time this morning.
Thanks