I have two curves and i want to make a LOFT body between them
Note: I attache the file.
Thanks in advance
You can not make a LOFT between "3DSketch4" and "Curve1". You need to convert the curve1 further into a 3d sketch. Check what I've done with the curve2.
For this start a new 3d sketch. Now select the curve1 and hit convert entities. Now loft between the two 3d sketches.
Convert the project curve into a 3d sketch and then use both of them for loft.
Thanks Deepak BUT the file you sent is a LOFT between projection curve NOT between the "3Dsketch4" and "Curve1"
If you check in more details, I've convert that curve into another 3d sketch. So the loft is between two 3d sketches.
Dear Deepak , I think this is the correct file
I need to make a LOFT between "3DSketch4" and "Curve1"
sorry for this confliction
Retrieving data ...