2 Replies Latest reply on Jan 29, 2007 4:56 PM by Chad Posner

    Static Analysis - Applying a Load to a Planar Surface??

    Chad Posner
      I am using SW06 with Cosmos.  I have a part where I havecreated a planar surface on a flat face of a part .  Thisplanar surface is where the Load will be applied.  Cosmos willnot let me select the Surface created but only the face on whichthe surface lies.  This is critical because the surfacecreated is much different than the entire face.  I am using asolid mesh for part.  

      Any help is greatly appreciated.  Thanks!

      Chad