3 Replies Latest reply on Mar 10, 2014 10:13 AM by Lenny Bucholz

    Extruding from Surface to Surface

    Garrett Smith

      I'm trying to create a boundary layer diverter for an aircraft fuselage. When I extrude the profile (Sketch28) to the inlet loft, it requires me to use a draft in order to use the extrude to surface feature. Why is this necessary?

       

      The other, bigger problem, is that there is a gap between the extrusion and the inlet loft when I extrude from the sketch to the fuselage, as shown in the image. Is there any way to fill that gap?