AnsweredAssumed Answered

SW 2014 SP2 Crash using Render in Photoview 360

Question asked by Henry Diem on Feb 24, 2014
  1. Does not matter what or how much parts and/or assemblies are open.
  2. Does not matter if original files are accessed.
  3. After I use PhotoView 360 to render files.
  4. Let the system idle for a few minutes.
  5. Place a finish, a material and a material
  6. When I try to perform another function.
  7. The system will crash. It only happens when I select the window to select any function.
  8. It does happen until I render using PhotoView 360